低觉醒脑电识别与唤醒的可穿戴系统研究

为智能化地识别警戒作业人员出现的低觉醒、注意力下降的生理状态，本文介绍了一种基于FPGA和脑电信号处理的低觉醒状态检测与唤醒系统，系统通过传感器从大脑头皮采集脑电信号，转换为数字信号，经傅里叶变换获取了脑电信号的θ相对能量、α相对能量、重心频率、谱熵等4个特征量，由4个特征量表征低觉醒状态并运用支持向量机对低警戒状态进行识别，当识别出低觉醒状态时采用声音报警模块发出声音，唤醒警戒作业人员。设计系统能够较好地识别出低觉醒状态，识别率达90.8%，可为提高警戒作业工作绩效提供一种可穿戴的智能装备。     

基于三相幅度测量的相控阵天线快速校准方法

提出了一种基于三相幅度测量的相控阵天线快速校准方法。该方法将天线阵列进行分组,利用每种分组在三种配相下的阵面合成场幅度测量值,可解算出各个天线单元的初始幅相值。该方法仅需幅度测量,避免了相位测量误差影响单元幅相值的计算精度,而且所需幅度测量次数仅为(2N+1)次,可显著提高校准时效性。另外,利用分组思想,同时改变多个单元相位,使总辐射场的幅度变化显著,提升校准准确性。仿真结果表明:校准后相位均方根误差为2.2°,幅度均方根误差为0.2 dB。     

干扰条件下的“北斗”信号解扩重构DOA估计

在干扰条件下，卫星导航抗干扰波束形成算法往往需要卫星信号波达方向（Direction-of-Arrival，DOA）的先验信息。但当存在低信噪比信号或主动干扰源时，常规的DOA估计算法性能急剧下降甚至失效。针对此问题，提出了一种被干扰信号压制的低信噪比“北斗”信号的DOA估计算法。该算法首先通过对接收信号进行子空间投影抑制干扰信号，然后对抑制干扰后的信号进行解扩重构处理，最后通过多重信号分类算法完成对“北斗”信号的DOA估计。仿真结果表明，在干扰信号干信比80 dB条件下，“北斗”信号DOA估计误差在5°以内，为下一步进行波束形成计算提供了高精度的入射角信息。     

Off‐grid DoA estimation method of wideband signals

In this paper, an off‐grid direction of arrival (DoA) estimation method is proposed for wideband signals. This method is based on the sparse representation (SR) of the array covariance matrix. Similar to the time domain DoA estimation methods, the correlation function of the sources was assumed to be the same and known. A new measurement vector is obtained using the lower‐left triangular elements of the covariance matrix. The DoAs are estimated by quantizing the entire range of continuous angle space into discrete grid points. However, the exact DoAs may be located between two grid points; therefore, this estimation has errors. The accuracy of DoA estimation is improved by the minimization of the difference between the new measurement vector and its estimated values. Simulation results revealed that the proposed method can enhance the DoA estimation accuracy of wideband signals.     

Study on maximum power point tracking of photovoltaic array in irregular shadow

Traditional maximum power point tracking (MPPT) methods can hardly find global maximum power point (MPP) because output characteristics curve of photovoltaic (PV) array may have multi local maximum power points in irregular shadow, and thus easily fall into the local maximum power point. To address this drawback, Considering that sliding mode variable structure (SMVS) control strategy have such advantages as simple structure, fast response and strong robustness, and P&O method have the advantages of simple principle and convenient implementation, so a new algorithm combining SMVS control method and P&O method is proposed, besides, PI controller is applied to reduce system chattering caused by switching sliding surface. It is applied to MPPT control of PV array in irregular shadow to solve the problem of multi-peak optimization in partial shadow. In order to verity the rationality of the proposed algorithm, the experimental circuit is built, which achieves MPPT control by means of the proposed algorithm and P&O method. The experimental results show that compared with the traditional P&O algorithm, the proposed algorithm can fast track the global MPP, tracking speed increases by 60% and the relative error decreased by 20%. Moreover, the system becomes more stable near the MPP, the fluctuations of output power is greatly reduced, and thus make full use of solar energy.     

Sensor interpixel correlation analysis and reduction for color filter array high dynamic range image reconstruction

High dynamic range imaging (HDRI) by bracketing of low dynamic range (LDR) images is demanding, as the sensor is deliberately operated at saturation. This exacerbates any crosstalk, interpixel capacitance, blooming and smear, all causing interpixel correlations (IC) and a deteriorated modulation transfer function (MTF). Established HDRI algorithms exclude saturated pixels, but generally overlook IC. This work presents a calibration method to estimate the affected region from saturated pixels for a color filter array (CFA) sensor, using the native CFA as a matched filter. The method minimizes color crosstalk given a set of candidates for proximity regions, and requires no special setup. Results are shown for a 21‐bit HDR output image with improved color fidelity and reduced noise. The calibration reduces IC in the LDR images and is performed only once for a given sensor. The improvement is applicable to any HDRI algorithm based on CFA image bracketing, irrespective of sensor technology. Generalizations to subsaturated and supersaturated pixels are described, facilitating a suggested irradiance‐exposure dependent point spread function charge repatriation strategy.     

基于GL0816传感器的高速线阵CMOS相机系统设计

为了满足印刷等高端工业检测中物体快速运动,需要大幅面、高行频、高分辨率图像采集等要求,研发了一款微米级高分辨率、高速线阵工业相机。首先,介绍了高行频、高分辨率国产CMOS图像传感器GL0816的功能与特点。然后,基于该芯片设计了一套高速大幅面高分辨率线阵工业相机系统,该系统采用FPGA作为整个系统的控制核心,以DDR3LSDRAM作为图像缓存器,以GigE vision2.0协议为输出标准,以SFP+作为高速图像输出接口。最后,搭建相机系统测试环境,对所设计的相机进行系统测试。结果表明:该相机系统行分辨率为8 192,可连续采集2 000行作为一帧图像输出,行频为50kHz,动态范围为57.32dB,信噪比为40.95dB,具有实时图像采集功能。该相机系统具有大幅面、高帧频、高分辨率、高信噪比、宽动态范围等优点,适用于印刷检测行业快速运动目标捕获成像及图像实时显示。     

Estimation of anisotropic properties of nano-structured arrays by modal vibration control at microscale

Nano-structured arrays are engineered to meet the requirements of a variety of applications such as microfilters, sensors, and structural interface due to their unique mechanical characteristics, which cannot be achieved by conventional solid materials. However, it is hard to evaluate the elastic properties of nano-structured arrays owing to the discrete structure, sample size, and availability of suitable techniques. To facilitate this, we develop an advanced three-dimensional microscale vibration testing process. In the test, a specially designed three-dimensional microspecimen with tuned mass is excited by a piezoelectric actuator, and the resonance frequencies are detected by a laser device successfully. The anisotropic elastic moduli of nano-structured array composed of helical nano-springs are identified from a single spectrum. This array shows so strong characteristic anisotropy that the solid one hardly can attain. The microscale testing technique can be extended to other materials and microstructures.